Guide

Ice barrier code: where it is required

Short answer

IRC R905.1.2 requires an ice barrier where there has been a history of ice forming at the eaves, as designated by the jurisdiction in Table R301.2. It runs from the eave edge to at least 24 inches inside the exterior wall line.

Where it applies

The jurisdiction fills in Table R301.2 (“Ice barrier underlayment required: yes/no”). Colder climate zones usually say yes, but the table – not the map – decides.

What it consists of

  • At least two layers of underlayment cemented together, or
  • a self-adhering polymer-modified bitumen sheet in place of normal underlayment,
  • from the lowest edges of all roof surfaces to at least 24 inches inside the exterior wall line. Wide overhangs and low slopes therefore need more than one course.
  • Detached accessory structures without conditioned floor area are excepted.

Valleys

Valley lining is a separate requirement (IRC R905.2.8.2) and is needed whether or not an eave ice barrier is required – see valley flashing code.

Quantity

Eave length × width of coverage needed to reach 24 inches inside the wall (overhang + 24 in., rounded up to full courses), in square feet. Valleys: length × 3 ft for a 36-inch lining.

Codes are adopted by states, counties and cities, often with amendments. The edition and amendments adopted where the house stands are what count – section numbers here follow the 2021 IRC model code. This guide is general information, not legal advice.

Sources

Let us document it for every job

Roofpol Unlimited: line items, quantities and the code and manufacturer support – $1,000 a month, unlimited, 3 test cases free.

Start 3 free cases See a sample package

Related

Start 3 free cases