Chimney cricket code: the 30-inch rule
IRC R903.2.2 requires a cricket or saddle on the ridge side of any chimney or penetration more than 30 inches wide, measured perpendicular to the slope. It is covered with sheet metal or the same material as the roof covering.
How to check
Measure the chimney width across the slope. Over 30 inches and no cricket on the photos: the cricket belongs in a code-compliant replacement. Unit skylights are excepted.
In the estimate
Cricket framing and covering, chimney flashing (base, step and counter flashing) and, where needed, a mason for counter flashing reglets. Photograph the chimney with a tape measure in view.
Codes are adopted by states, counties and cities, often with amendments. The edition and amendments adopted where the house stands are what count – section numbers here follow the 2021 IRC model code. This guide is general information, not legal advice.
Sources
Let us document it for every job
Roofpol Unlimited: line items, quantities and the code and manufacturer support – $1,000 a month, unlimited, 3 test cases free.
Related
- Roof Supplement Service
- Roof Estimating Service
- Drip Edge Code Requirements
- Starter Strip Requirements for Shingle Roofs
- Ice and Water Shield Code
- Roofing Underlayment Code Requirements
- Valley Flashing Code
- Step Flashing and Kick-Out Flashing Code
- How Many Layers of Shingles Are Allowed? Roof Overlay Code
- Shingle Nailing Pattern and Roofing Nail Code